Loading..

Product was successfully added to your shopping cart.





Navigation

Weapons Related

Weapons Related

 
  • Standard issue "Hip Holster" for the M-1911 and M-1911A1 pistols. These holsters are genuine military contract holsters. Holster manufacturer on back may vary depending on availability, but they are all marked and have the government contract number. These are all "real" USGI holsters. Hard to find real holsters and you can't beat the quality! Holsters are in unissued condition. Because these are New Old Stock, you need to exercise care when first opening the holster. The leather is tight and dry and if you just pull on the flap, you WILL pull out the male press stud and ruin the holster. You need to gently work the flap the first couple of times and it is even better if you condition the leather and then use care opening. Once they have been used, there is no problem. Learn More

    Holster, M-1916, USGI

    $100.00
  • Standard issue "Shoulder Holster" for the M-1911 pistols (will also fit the Beretta M9 series) . Commonly seen in use by aviators, tankers, etc. These holsters are in new condition and made by government contractors. They are not import copies. Holsters are complete with NSN codes, etc. Learn More

    Holster, M-7 (M1911 .45 ACP)

    $80.00
  • "Hollywood" M-14 Blank Adapter (BFA) for M14 / M1A Rifles. These are "Hollywood" BFAs and cannot be seen when installed. Simply loosen the set screw on the front of the site base, remove the castle nut, remove the flashider, inset the adapter into the flashider (narrow end out) and reassemble. Priced per BFA, flashider not included. Blank adapters are machined from cold rolled 1018 steel for durability. All of our M14 BFA's come with the "starter" stock aperture size of 0.110 which should work in most rifles with the weaker Austrian L31A1 blanks. It will also work as a pilot hole to drill them out for more powerful blank loads (primarily European military .308 blanks or USGI Blanks). It is important to note that even though they use same nomenclature designation, there can be a difference in power based on country of origin. For example, British Radway Green L31A1 blanks (head stamp RG) are hotter than Austrian L31A1 (head stamp HP). For most blanks, you will need to enlarge the hole. Below are some rough guidelines for sizes that we have found to work. This is very important! Guidelines for Drilling Out Blank Adapters: Swanson (.187) USGI Blanks (.171) Radway L31A1 Blanks (.136) Austrian L31A1 Blanks (.110) *These sizes work in both semi and full auto in a USGI H&R M14. They may take some tweaking for your rifle. Speak with the manufacturer of your blanks to get a ballpark starting range! This information is included as a guide. We are not responsible for damaged weapons or body parts! CHECK FIRED BRASS FOR DAMAGE. IF THE BRASS IS MANGLED, THE APERTURE IS TOO TIGHT AND NEEDS TO BE OPENED. IF YOU ARE UNSURE, ASK THE MANUFACTURER OF YOUR BLANKS WHAT SIZE HOLE HE RECOMMENDS! FAILURE TO USE THE CORRECT DIAMETER HOLE CAN RESULT IN SERIOUS PERSONAL INJURY AND / OR DAMAGE TO YOUR RIFLE Learn More

    "Hollywood" M-14 Blank Adapter (BFA)

    $15.00
  • "Hollywood" M-16 Blank Adapter (BFA) for M16 / AR15 Rifles. These are "Hollywood" BFAs and cannot be seen when installed. Simply remove the flash hider and drop in the adapter with the narrow end facing the out towards the end of the flash hider and the broad end against the base of the muzzle. Blank adapters are machined from cold rolled 1018 steel for durability. Priced per BFA. We make three different sizes for these blank adapters: USGI blanks and Euro NATO surplus are the weakest blanks and use the smallest aperture. LAM blanks are a "mid-grade" blank with a loud retort, but not as loud and not as much flash as the Swanson Hot blanks. SWANSON HOT blanks are the loudest / strongest blanks on the market. USGI - for M200/M200A1 blanks (0.080) LAM - for Atlantic Wall "LAM" mid-power blanks (0.125) HOT - for Swanson's Motion Picture Blanks (0.175) CHECK FIRED BRASS FOR DAMAGE. IF THE BRASS IS MANGLED, THE APERTURE IS TOO TIGHT AND NEEDS TO BE OPENED. IF YOU ARE UNSURE, ASK THE MANUFACTURER OF YOUR BLANKS WHAT SIZE HOLE HE RECOMMENDS! FAILURE TO USE THE CORRECT DIAMETER HOLE CAN RESULT IN SERIOUS PERSONAL INJURY AND / OR DAMAGE TO YOUR RIFLE! Learn More

    "Hollywood" M-16 Blank Adapter (BFA)

    $15.00
  • M-16 3-Prong Flash Hider. This is the earlier 3 Prong Flashider commonly seen on M-16's and XM-16E1's. It was replaced by the full bird cage seen below starting in 1967. Will fit all standard threaded 1/2 x 28 AR-15 / M-16 rifles. Learn More

    M-16 3-Prong Flash Hider

    $20.00
  • M-16 / M16A1 Full Bird Cage Flash Hider. This is the standard "full bird cage" flashhider that came into use in 1967. Will fit all standard threaded 1/2 x 28 AR-15 / M-16 rifles. Learn More

    M-16A1 Full Bird Cage Flash Hider

    $20.00
  • This is the third pattern XM3 Bipod Case for the M3 Bipod. The case is made from cotton canvas and is intended for use with the M-16 rifle. These OD cotton carriers were designed to carry the basic folding M3 bipod and they have the external pocket for cleaning supplies as well as the side pocket with flap meant to carry the three piece cleaning rod (a 4 piece will work as well). We have both G/VG used and EXC condition available. We have one EXC condition with a broken zipper as well. Learn More

    XM3 Bipod Case, Canvas (3rd Pattern)

    $25.00
  • M-16 Cleaning Kit. This is a standard cleaning kit with pouch for the M16 series of rifles. Kit includes nylon pouch, 4 piece rod, patch pull, chamber brush, bore brush, utility brush, and Oil bottle. Small accessories like thin metal brush, patches and pipe cleaners generally not included. Pouch is a modern commercial copy and is not US marked, but you can add a US marked contract pouch for $10 (they are $15 seperately). Learn More

    M-16 Cleaning Kit

    $25.00
  • M-16 Cleaning Kit Pouch, USGI. This is an unissued USGI surplus cleaning kit pouch for the M16 rifle. Pouch is marked "Case, Maint. Equip., M16A1 Rifle." Perfect to build your own cleaning kit or to replace a pouch you currently have. Learn More

    M-16 Cleaning Kit Pouch, USGI

    $15.00
  • Rifle Bore Cleaner. We finally found another small stash of rifle bore cleaner. Bottles are 1969 dated and are 2 ounce size. Straight from the original cardboard box. Due to evaporation most of these are not completely full despite being sealed. We do have a sealed case available (48 bottles). The Price for the case also includes the increased shipping fees. Learn More

    Rifle Bore Cleaner

    $12.00